Avermedia EXR6004 Manuel d'utilisateur télécharger pdf (Page 19)

2.2.1 Setting Up and Using the Emap

E-Map can hold up to 8 maps in *.jpg format. You may locate the camera, sensor and relay on the map.

2.2.1.1 To Set Up the Emap

1. Click Emap.

2. When the Emap screen appears, click the area number (1 to 8 buttons) on where you want to insert

the map.

3. Click Load Map to insert the map. When the open dialog box appears, locate and select the map and

click Open.

4. When the inserted map appears on the Emap screen, click Edit. You may now drag the camera,

sensor, and relay icons to its place on the map. Icons on the map can be relocated anywhere. If you

are going to locate the icon on the map to other area, you need to drag the icon to the black pane at

the bottom of the Emap screen and then switch to the area on where you want to locate the icon. To

bring all the icons back to the black pane at the bottom of the Emap screen, click Reset Icon.

5. When you are done, click Save button to save the new setting. To exit Emap screen, click Close.

2.2.1.2 To Use the Emap

1. Click E-map.

2. In the Emap screen, click the camera icon to switch on the area where the camera is located on the

map and to display the video at the upper right corner of the Emap screen. At the lower right corner of

the Emap screen, it lists all the warning message.

3. To view different Emap, click Emap number button (1 ~ 8).

4. Click Close to exit Emap screen.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 116 117

Pas de commentaire

Avermedia EXR6004 Manuel d'utilisateur Page 19